Went out to do a job with above set-up using Mobile Mapping mode with diff processing. Some comments: at start the date on the pm3 is still off-I had to wait a few mins before it corrected itself in setup/utilities/date & time - I thought this had been fixed or does the processing software may sort this out later?
I had the sbas corrections turned off in the pm3, but noticed in the post processing some points were sbas corrected [therefore not diff processed]- can this be turned off as sometimes I avg a base stn position & this gives different results, particularly in height.
Some new features have been incorporated in above upgrades when using the pm3 software - is there any explanation or manual that mentions these changes?