Is there a way to import coordinates into a Locus project?
I have a lot of points with known xyz that I would like to use as initializing points for an additional kinomatic topo. It's too tedius to enter each in the control sites tab.

Charlie,

Unfortunately, there is no way to import known coordinates into a project. Good idea though. I will add it to the list of requested new features for a future release.

Bill Martin
Asthech Precision Products

I am wondering how that would work if you had no measurement raw data associated with the site. Otherwise, seems you could have common points in multiple jobs and then import the O file.

You may try keeping your job with your control, something like a control job only. Adjusted and set up like you would like.

You could then import new data into this project. The points that where on known points, name them the same site ID as the control points. Once you process the unprossed data, and adjust just do a "save as" to save this new project.

I think this is what you are asking for.

Best Regards.
RB