I thought maybe the team feeling in survey ahad gone and competion took over. this site disproves that. I adjusted the mask angle and took out two bad sv's and got a fix!

Don't be surprised if when you re-process it that it shows that same vector as failed again. Just go back and set your mask angle up or down a degree or two and reprocess. Then go back in and set it back to what you had before you reprocessed and reprocess it again and it should come back in. I don't know why it does this and I never think to ask on the board here or check with tech support, but it does. I discovered this when I would process holding more control points as fixed after getting a decent solution dong a minimally constrained process.

One of those things.

Greg